Molded of hard rubber, hollow in the middle, 84" in length. Choose from with 3 different heights. Height measurement is the flat back where it is fastened to the trailer. Comes with pre-cut recessed holes for bolt-on installation. If the length of your bumper is shorter than 84", you may still order this bumper, but please measure the bolt-hole locations carefully! These bumpers are hollow, and can be cut with a saw. They can also be drilled with additional bolt holes (do it yourself).
Pre-drilled bolt holes for Option A: The first bolt hole center is placed 3 inches from each end. The remaining bolt hole centers are 18 inches apart. 6 holes total. The holes are drilled for a 3/4" bolt (not supplied).
From the left side: bolt holes are centered at 3", 21", 39", 57", 75", 93"
Pre-drilled bolt holes for Option B: The first hole center is placed 2" inches from each end, then the remaining hole centers are 11 1/2" inches apart. The recessed holes are drilled for a 3/8" bolt (not supplied).
From the left side: bolt holes are centered at: 2", 13 1/2", 25", 36 1/2", 48", 59 1/2", 71", 82 1/2", 94"
OFC: An extra charge in addition to flat-rate shipping charges for shipping a LARGE, HEAVY OR LONG item by ground.
Trail Pals tip: For accurate measurements, lay the bumper on a flat surface & measure the flat back for the hole pattern.