Trailer Bumper, Round Rubber -8ft / 96" long, w/ Pre-Drilled
Holes, in choice of 3 heights and 2 different drilled holes measurement.
Molded of hard rubber, hollow in
the middle, 84" in length. Choose from with 3 different heights.
Height measurement is the flat back where it is fastened to the trailer. Comes
with pre-cut recessed holes for bolt-on installation. If the length of your
bumper is shorter than 84", you may still order this bumper, but please
measure the bolt-hole locations carefully! These bumpers are hollow, and can be
cut with a saw. They can also be drilled with additional bolt holes (do it
Pre-drilled bolt holes for Option A: The first bolt hole center is placed 3 inches
from each end, then the next bolt hole centers are 12 inches apart. The
remaining 3 holes in the middle are placed 18" apart. 6 holes total. The
holes are drilled for a 3/4" bolt (not supplied).
From the left side: bolt holes are centered at 3", 15", 27", 51", 69", 81"
Pre-drilled bolt holes for Option B: The first hole center is placed 2" inches
from each end, then the remaining hole centers are 11 1/2" inches apart.
The recessed holes are drilled for a 3/8" bolt (not supplied).
From the left side: bolt holes are centered at: 2", 13
1/2", 25", 36 1/2", 48", 59 1/2", 71", 82
OFC: An extra charge in addition to
flat-rate shipping charges for shipping a LARGE, HEAVY OR LONG item by
Trail Pals tip:
For accurate measurements, lay the bumper on a flat surface &
measure the flat back for the hole pattern.