Molded of hard rubber, hollow in the middle, 84" in length. Height measurement is the flat back where it is fastened to the trailer. Comes with pre-cut recessed holes for bolt-on installation. If the length of your bumper is shorter than 84", you may still order this bumper, but please measure the bolt-hole locations carefully! These bumpers are hollow, and can be cut with a saw. They can also be drilled with additional bolt holes (do it yourself).
Pre-drilled bolt holes: The first bolt hole center is placed 3 inches from each end, then the next bolt hole centers are 12 inches apart. The remaining 3 holes in the middle are placed 18" apart. 6 holes total. The holes are drilled for a 3/4" bolt (not supplied).
From the left side: bolt holes are centered at 3", 15", 33", 51", 69", 81"
OFC: An extra charge in addition to flat-rate shipping charges for shipping a LARGE, HEAVY OR LONG item by ground.
Trail Pals tip:
For accurate measurements, measure the mounting area on the trailer side for the hole pattern, or lay the bumper on a flat surface & measure the flat back for the hole pattern.