Toggle Switch Cup with one opening
Choose from 20 gauge zinc plated steel, aluminum, or sturdy black plastic (different clearances)
The traditional 20 gauge zinc-plated steel AND the aluminum switch cup fit in a one inch deep, 2 1/8" - 2 1/4" diameter hole, protecting the toggle switch from accidental engagement. You will need 1 1/2" of clearance in the wall to install these switch cups with our toggle switch, part # TS12VBLADE. Each outer frame is 3 3/8" diameter. Mount with rivets or three #10 X 1" screws, sold below or on the Fastener page.
The sturdy black plastic switch cup requires the same hole size, but is different, as the cup is 1/8" deeper & the switch position is arranged so the toggle switch would be placed in the slanted TOP inside the cup, positioned vertically. This allows for LESS clearance inside the wall: You will only need 1 1/8" clearance If this switch cup is installed with our toggle switch, part# TS12BLADE. The mounting holes & screws are the same as above. Perfect for both steel & aluminum trailers.