Tie Ring Mounting Hardware, Stainless Steel (REUSABLE!)
Choose from 3 wall thicknesses.
We recommend that all of our tie rings be installed with stainless steel hardware, on both aluminum & steel horse trailers. Who wants to see rust running down the wall of your beautiful new horse trailer?
The aluminum tie ring is designed to break in an accident before it pulls a hole in your expensive trailer. This mounting hardware we have put together is able to be re-used to mount a replacement tie ring, instead of starting all over with new hardware and a trip to the hardware store. It is unlikely that the stainless steel tie ring can be broken by a horse, so you will be dealing with rust drips if they are installed with regular steel hardware.There are no sharp edges on either side, it will never rust and the installation looks neat and professional. Yes, they are spendy, but you can re-use these tie ring fasteners & over again as needed, for the life of the trailer!
Use a 3/8" drill bit for the exterior hole where the truss bolt installs, and a 7/32" drill bit for the interior hole where the machine screw & washer install. The Truss Head goes through the mounting holes on the tie ring, and the screw & washer adjust from the inside of the trailer.
**You will receive two Stainless Steel Threaded Truss Bolts, two Stainless Steel Machine Screws & two Stainless Steel 1 1/4" washers in each order (enough to mount ONE tie ring with 2 holes.). We have calculated for the thickness of the tie rings:
Mounting Hardware for Tie Rings, KIT #1: for 1"-1 3/4" walls
Mounting Hardware for Tie Rings, KIT #2: for 1 3/4"-2" thick walls
Mounting Hardware for Tie Rings, KIT #3: for 2 1/2"-2 3/4" thick walls
