Horse Trailer Wall Pads, 9" X 12"
Made in the USA
The standard color is black, with a grain design on it that resembles leather.
Important Product Info: These pads are constructed of a soft, but strong vinyl, sewn over 1" foam onto a rigid chip board (cardboard) backing. This creates a 1" flat border area. We have had them in our trailer (stored outdoors in a rainy environment) for three years with no problem.
Pad your slant-load and straight-load trailer dividers and walls. Mount with appropriate fasteners along the 1" border, where there is no padding.
Single rectangular trailer pads in any combination are priced as follows:
9"W X 60"L
9"W X 40"L
9"W X 24"L
9"W X 12"L
60" pads are for side walls with no access doors or slant-load dividers, sold below.
*60" trailer pads have an extra charge of $5. EACH for the oversize box (shipper charges).
40" pads are for trailer walls with escape doors or slant-load dividers.
*40" trailer pads have an extra charge of $2. EACH for the oversize box (shipper charges).
24" pads are for breast or butt pads.
*24" trailer pads have an extra charge of $1. EACH for the oversize box (shipper charges).
12" pads are for escape doors. (12" pads have no extra shipper charges)
Horse Trailer Pad Fastener Options:
If your mounting surface is under 1" thick, we sell inexpensive #8 1/2" or 3/4" long steel/zinc screws & washers to mount these pads to any wood, steel or aluminum trailer surface.
If your mounting surface is over 1" thick in a hollow or insulated wall, we have Plastic Black Retainer Clips, also known as “Push Pins", in 2 lengths (looks professional).
If your mounting surface is at least 1" thick or in a hollow or insulated wall, we offer a coated black #10 x 1 inch screw (actually 7/8") with a counter-sunk washer attached (looks nice).
HOW MANY DO YOU NEED? Our (Minimum) Suggestion:
4 fasteners for each 12" pad
8 fasteners for each 24" pad
10 fasteners for each 40" pad
14 fasteners for each 60” pad