**************************
 |
For aluminum, diamond-plate or
steel fenders Fender Trim is
a necessity for horse trailers, to prevent injury to
horses tied to to the side of the trailer.
And let's just say---we are frustrated
with cheap glue-on fender trim! Either the horses paw it
off, or the glue fails & it starts hanging off the
fenders, leaving an ugly residue. Fender trim with small
aluminum clips inside is the way to go, because it is
easy to install & easy to fix, with no tools
involved. If a horse paws it off, just push it back on
again. You can pull off what is left of the
glue-on product & install this right over it.
Please measure the width at the
edge of the trailer fender, then choose the product
that matches best. Measure the fender edge from where it
meets the trailer in the front to the same place in the
rear. (You will need 8-12 feet for each side.) Fender
trim is priced by the foot & comes in one continuous
piece. Don't remove the old product
until your order arrives. You may want to secure each
end with a rivet or small screw. Our fender trim isn't
plain---it has a "fine pebble" surface design on it. |
